GSO ISO 3685:2013
Gulf Standard
Current Edition
·
Approved on
31 December 2013
·
Tool-life testing with single-point turning tools
GSO ISO 3685:2013 Files
English
48 Pages
Current Edition
Reference Language
You can buy this standard from any member store
GSO ISO 3685:2013 Scope
This International Standard specifies recommended procedures for tool-life testing with high-speed steel, cemented carbide and ceramic single-point turning tools used for turning steel and cast iron workpieces. It can be applied in laboratory testing as well as in production practice.
In turning, cutting conditions may be considered under two categories:
a) conditions as a result of which tool deterioration is due predominantly to wear;
b) conditions under which tool deterioration is due mainly to other phenomena such as edge fracture or plastic deformation.
This International Standard is solely concerned with recommendations for testing which results predominantly in tool wear.
Testing for the second category of conditions above is to be subject to further study.
This International Standard establishes specifications for the following factors of tool-life testing with single-point turning tools: workpiece, tools, cutting fluid, cutting conditions, equipment, assessment of tool deterioration and tool life, test procedures and the recording, evaluation and presentation of results.
Further general information is given in annex A.
NOTE 1 This International Standard does not constitute an acceptance test and should not be used as such.
Best Sellers From Mechanical Sector
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
GSO 98:1988
Gulf Technical Regulation
MOTOR VEHICLES- FLAMMABILITY OF
INTERIOR MATERIALS AND THEIR
TESTING METHODS
GSO 1780:2010
Gulf Technical Regulation
Motor vehicle-vehicle identification number (vin) - requirements
Recently Published from Mechanical Sector
GSO ASTM D4778:2024
ASTM D4778:15
Gulf Standard
Standard Test Method for Determination of Corrosion and Fouling Tendency of Cooling Water Under Heat Transfer Conditions (Withdrawn 2024)
GSO ISO 21384-2:2024
ISO 21384-2:2021
Gulf Standard
Unmanned aircraft systems — Part 2: UAS components
GSO ISO 24513:2024
ISO 24513:2019
Gulf Standard
Service activities relating to drinking water supply, wastewater and stormwater systems — Vocabulary
GSO EN 14622:2024
EN 14622:2005
Gulf Standard
Devices to prevent pollution by backflow of potable water - Air gap with circular overflow (restricted) - Family A, type F